MOTOSPRAY STONE GUARD
TEXTURED UNDERBODY COATING
MOTOSPRAY Stone Guard is a textured under body coating that protects against stone chips and road abrasion
Size 400G
Colour Black
Available from
Description
MOTOSPRAY Stone Guard is a rapid drying, flexible, textured coating for protection against salt, moisture, rust, and general road abrasion. Ideal for use in the repair of underbody area
Additional information
| Size | 400G |
|---|---|
| Colour | Black |
SURFACE PREPARATION: Remove rust using a grinder, wire brush and sandpaper. Treat light rust and bare metal with MOTOSPRAY Deoxidiser & Rust Remover. Complete all necessary repairs. If required apply a suitable primer for the surface. Plastic substrates must be cleaned, then primed with MOTOSPRAY Bumper Primer. Non-ferrous metals such as aluminium and galvanised steel must be primed with an appropriate primer such as MOTOSPRAY Etch Primer. Sand all surfaces to be coated with P320-400 grit paper to promote adhesion. Ensure that the surface is clean, dry and dust free by cleaning with MOTOSPRAY Prepwash. Mask off surrounding areas to avoid over spray.
APPLICATION: Shake can vigorously for one minute after the sound of the agitator is heard. Spray in even overlapping pattern from a distance of approximately 25-30cm. Apply 2-3 light coats allowing 5-10 minutes flash off between coats. To obtain the desired texture and film build, perform test sprayouts. It is important to keep the can in motion when spraying, to avoid excessive film build.
DRYING TIME: Allow to air dry for approximately 4 hours at 20°C Allow longer at lower temperature and for higher film thickness. Overnight drying is recommended.
CLEAN UP: Use MOTOSPRAY Gunwash.
